Add Chain & ETH Faucet
Last updated
Last updated
To add the Holesky Network to your wallet, visit ChainList (), connect your wallet, enable testnets, enter Chain ID 17000, and click "Add Network."
To use Morph's public testnet, obtain testnet ETH on Holesky, then bridge it to the Morph testnet.
Here are a few Holesky faucet apps:
Once you receive ETH on Holesky, you should see it in your wallet on the Holesky Network.
Bridge transaction times can vary depending on network traffic. It typically takes a few minutes to complete. You can check the status of your transaction here.
Following the same steps as adding Holesky Network, connect your wallet on ChainList (), enable testnets, enter Chain ID 2810, and add the Morph Holesky Network.
It may take a few seconds for them to appear, but you can check the status by looking for a transaction to your address on the .
📌You can check Morph's official guide to learn more about this.
Before you mint on Morph Holesky, bridge your Holesky ETH to Morph Holsky using this link:
📌You can check Morph's official guide to learn more about this.